| ¡ | Select Options in the Tools menu and specify required parameter on the tab |
Main options
System Options
|
Enable Write
|
If selected, Restorer2000's Text/Hexadecimal Editor is able to physically write data on a disk.
|
Debug mode
|
If selected, Restorer2000 starts operating in the debug mode. This switch greatly slows Restorer2000.
|
Read attempts
|
Number of read attempts during access to the drive. If there are bad sectors on the drive, increase the value of this property. This may help to successfully read those sectors. Sometimes, if this parameter is set too large and there are some unreadable sectors on the hard drive, the hard drive-controller pair may refuse to perform any successive read/write operations with the entire hard drive when it fails to read/write such sectors. In this case, set this parameter to zero.
|
Hints
|
Show All Warnings and Confirmations
|
If selected, Restorer2000 will show all warning messages for which the Never show again option has been selected.
|
Disable All Warnings and Confirmations
|
If selected, Restorer2000 will never show any warning messages in which the Never show again option exists.
|
The settings are described in the Disk Scan section.
You may set which panels and bars to enable/disable.
Toolbar
|
Select/clear Toolbar in the View menu
|
Status bar
|
Select/clear Status bar in the View menu
|
The panel
|
Select/clear Event Log in the View menu
|
|
